Driving & Operating
Advanced Driver Assistance
System$(ADAS}
Tires & Wheels
Infotolnment
Replacing Tires and Wheels
Hlgh-voltogg Battgry Pock &
Chorglng
WARNING: Foryoursofvty. It 1$ rgcommendgd thotonty wh8el$and tires that
motch thgorlglnol $pe¢lficatlon org Usgd on the vehl¢lg.Speclficotion$ ft)r
authorlzed wlntgrtlrosorgavalloblg by¢onto¢tlng Flskgrvlotho FlskorApp.
Malntgnan¢&
WARNING: Opgratlon ofthe Integrated Tlrg Pressurg Monltorlng Systgm
(TPMSI moy bg offectgd Iflhellr8s are rgpla¢gd wllh a dlffergntSPo¢lficailon
from the orlglnol&
Tlres & Whe018
Wheel rlms and lires are matched to suitthe hondlSng charocteristics of the vehicle.
Always check that replacementtlres complywith the original specification. If tires
other thon those specified are used, ensure that the load and speed rollngs {shown on
the tire side wall) equal or exceed those ofthe original specificallon.
Tlro Informotlon
Tlro Caro and Malntonancg
For the speclficotSon ofthe orlglnal wheels and tlres Installed on thevehlcle, referto
Technlcal Data chapter of thls gulde.
Inspectlng and Ma5ntalnlng Tlres
Ideally, Ilres should be replaced as sets of four. If thls Is not PO88lble, reploc8th8tlr88 In
palr8 (front and rear). When Ilres are r8placed, the wheels should always be re-
balanced and allgnmentch8cked.
Molntolnlng Tlre Pressures
Replaclng Tlres and Wheels
Fl8ker orlglnal equlpmenttlres
Seasonal TlreTypes
Flsker orlglnal equlpmenttlres wlth the deslgnatlon FSR on the tlre 81dewall have been
8peclfically deslgned lo have a low rolllng reslslance, whllst provldlng a dynamlc and
stable drlvlng experlence.Fl8ker recommends only Installlng Ilres malchlng th18
orlglnal speclficatlon.
Drlvlng In LowTernperatures
Snowchalns
A8ymmetrlc non-dlrectlonal tlre8
WARNING: Vehlcletractlon and handllng wlll be serlougly Impalred Sf thetlre8
are Incorrectly In8talled on the wheel8.
Tlr• Pr•88ur• Monltorlng Sy8t•m
Tlr• R•palr
Yourvehlcle18 equlpped wllh Asymmetrlc non-dlrectlonal tlre8 that have dlfferenl
tread patterns on the outer and Inner edge of the tlre. On the outslde edge,thetread
pattern exhlblls large tread block8 whlch are deslgned to provlde good dry traction
and handllng thonks lo a larger contact area with the road. On the inslde edge, the
tread block is smaller to provide better wet grip, and an increased number of grooves
help disperse water and reduce the rlsk of aquaplanlng on wet roads.ThSs effectlvely
means thetire Is builtto provide greatall-around performance In both wet and dry
conditions.
SofetyPracauiions
Tlrè RèF)olr Kltovarvl
Tlrè ReF)olr Kltcomponènts
Uslng tha Tira Flapair Kit
Using th8 Compressor
Vahlcle Loadlng
GIo8saryofTefm8
Asymmetric tires must be mounted on the wheel with the correct sidewall facing
outwords from thevehicle. The sidewall ofthetire is marked with the word OUTSIDE
Technlcal Data
When newtires have been installed. always make sure thatthetires are correctly
orientated tothe wheel.
Roadside Assistance &
Emergency Informatlon
Run-flcrttlras
CAUTION: The installation of run-flattires Is not recommended by Fisker.
Consumer Informatlon
