OpenSky (Sliding Roof)
OpenSky (Sliding Roof)
The sliding roof is controlled by a switch on the overhead console, which operates as follows:
-
Tilt open: Gently pull up to the resistance point, then release. The sliding roof automatically opens to the tilt position.
-
Auto-open: Pull past the resistance point, then release. The sliding roof fully opens automatically.
-
Auto-close: Gently push up to the resistance point and release to auto-close from the tilt position. Push past the resistance point and release to auto-close from the fully-open position.
Note: Pushing or pulling the switch again during any operation stops the motion of the sliding roof.
The sliding roof can also be fully opened by either of the following methods:
-
If equipped, press the California Mode button on the key fob.
Note: This also opens all the power windows on the vehicle.
-
Use the Fisker App.
Note: Fisker App functionality may not be available at launch. It will be updated via OTA software updates when available.
Note: For safety reasons, OpenSky will not operate at temperatures of -25°C (-13°F) or below.